Characters of wheel alignment universal turntable:
● Built-in full floating ball bearing plate to ensure smooth movement of the wheels in all directions.
● Suitable for all wheel alignment machines and lifts, such as CCD, 3D wheel alignment machines, etc.
● With goniometer and hands, the large dial can be easily read from any angle and can be adjusted to the zero starting position at any time, allowing a maximum left and right 50 degree measurement (and a 360 degree rotation after take-off with the locking pin)
● Designed to be used as a portable floor unit or stand, rack or pit.
● Used to easily turn tires during four-wheel alignment tests, these dials can accurately indicate the steering angle of each wheel, allowing the bottom of the wheel to turn freely when making alignment adjustments.
● No need for a jack, as the turntable is designed to be non-slip to minimize slippage.
All the products we produce:
Use Instructions:
● Place the turntable on your workplace such as a flat floor, stand, shelf or pit.
● Remember to lock the turntable with the locking pin.
● Place the bridge next to the disc at the top of the turntable.
● Drive the car onto the turntable, making sure the tires are centered on the top plate of the turntable.
● Remove the locking pin
● Then you can turn the steering wheel to the position you want
● Put the thrust blocks under the tires
● You can perform a four-wheel alignment test
Products on production line:
Specification of wheel alignment clamp
Application | All wheel alignment machine and lift | Turntable size | L400*W400*H50MM |
Top base plate diameter | 345mm | Rotation degree | ±50° |
Raw material | Alu, steel, plastic | Color | Grey, red,etc |
Load capacity | 4-6 ton | Unilateral sliding distance | 65mm |
N.W | 36KGS/CTN | G.W | 38KGS/CTN |
Package | 2PCS/CTN | One set incl. | 2pcs turntables+2pcs passing bridges+2pcs thrust blocks |
FAQ:
Q1: Can the plates spin 360 degrees?
Yes, after loose the locking pin, it can turn 360 degree.
Q2: Is there a suddenly stop in the plates?
No, it turns smoothly.
Q3: What is the load capacity for the turntable?
4-6 tons load capacity.
Q4: Do they have bearings inside?
Yes, full-floating ball bearing plate made by polyurethane and steel.
Or if you want, we can provide steel bearing with full-floating ball bearing plate.
Q5: Did the rubber parts(passing bridges and thrust block) include to the turntables?
Yes, if buy turntable, you can get 2PCS free passing bridges and 2PCS thrust blocks inside.